This section provides general operating instructions for the KLIMAX KONTROL.
Standby mode
To exit or enter standby mode:
■Press STANDBY.
Source selection
Handset
To switch source:
■Press the key for the appropriate source (e.g.CD).
Note:
If you have used a source type more than once (see Source Setup,page 9), repeatedly press the appropriate source
key to cycle through the available sources.
Front panel
To switch source:
■Repeatedly press or hold SOURCE +/SOURCE – until the desired source is shown on the front panel display.
Volume
To adjust the volume:
■Repeatedly press or hold VOLUME +/VOLUME –.
Volume range is from 0 to 100 (in 200 x 0.5 steps).
Muting
To mute or unmute a source:
■Press MUTE.
Balance
Handset only
To adjust the balance:
■Repeatedly press or hold BAL L / BAL R.
Balance range is from 15 increments to the left, to 15 increments to the right.
Stereo/mono switching
Handset only
To toggle between stereo or mono output:
■Press MONO.
12