15
User Options
User Option Description Possible settings
MAX VOLUME Upper limit on the volume control.
BINDING If set to GLOBAL,the same volume and balance
settings are used for each source.If set to
PER SOURCE,separate volume and balance settings
are allowed for each source.
PRODUCT IR Enables or disables the infra-red receiver on the
front of the unit.
REMOTE IR Allows you to specify which remote infra-red device
the unit responds to or disables operation of the
unit via a remote infra-red device.
UNITS Units in which volume level is displayed.
LOGO The graphics used as the logo in the SLEEP DISPLAY
option.
KEY RATE Rate at which volume changes when VOLUME +/-
keys are held.
MUTE RATE Rate at which volume mutes/unmutes when
switching sources or muting/unmuting.
BRIGHTNESS Brightness of front panel display.
RS232 CONNECTION Enables or disables the RS232 circuitry.
DEVICE ADDRESS Which RC5 addresses the unit will respond to.
INSTALLER SETUP* To reset the unit to the settings defined by the
installer when the unit was first configured,set to YES.
FACTORY SETUP** To reset the unit to the settings defined at
(only appears if installer manufacture (i.e.the defaults shown in the
settings have been altered.) right-hand column and a blank set of source
setups),set to YES.
100/(+10dB),0/(- ) to
100/(+10dB)
GLOBAL,PER SOURCE
ENABLED,DISABLED
RCU,NOTHING,MOGEYE
NUMERICAL,dB
Linn logo,musical notes
21,range 1 (slowest) to 40
(fastest)
3,range 1 (slowest) to 10
(fastest)
15,range 0 (dimmest) to
15 (brightest)
ENABLED,DISABLED
HANDSET,0x10, 0x13
NO,YES
NO,YES
* If set to YES, the unit will display names given to sources during initial source setup.
** To reset the factory defaults,you must first reset the installer settings (set INSTALLER SETUP option to YES) then exit
and re-enter user options mode.