Linn KNEKT Multi-room owner manual Clock feature, Controlling the KNEKT system by remote control

English KNEKT RCU operation

Clock feature

To display the clock:

●Press repeatedly to step you through the clock display options available – i.e. time with seconds; time without seconds; date; day and time.

To set the clock:

●Press , and then and DO simultaneously.

The display shows the current time, with the hours flashing.

●Use the ‘multi-function’ keys to change the value of the flashing number, or DO to select the next time or date field.

●When you have set the required time and date, press to store the new values and start the clock. Pressing any other key cancels the changes you have made, and restores the original time and date.

Note:

When the time is updated, any alarm settings stored in the KNEKT RCU (see the Alarm Function section later in this manual) will be cancelled.

To perform a system clock update (INTERSEKT based systems only):

If your KNEKT system incorporates the INTERSEKT, at the end of the above sequence the following display will appear:

‘System time update?’

And the ‘X’ ‘’ options will appear above the ‘multi-function’ keys.

●Press the right hand ‘multi-function’ key (below the ‘’ ), to update all KNEKT RCU clocks in the system.

OR

●Press the left-hand ‘multi-function’ key (below the ‘X’), to update only the KNEKT RCU in that room.

Controlling the KNEKT system by remote control

If you have a Linn remote control handset that includes the WHERE, WHAT, DO and ‘multi-function’ keys, then this can be used to control the KNEKT RCU. Use these keys exactly as you would use the equivalent keys on the KNEKT RCU (see KNEKT RCU operation, above).

The KNEKT RCU’s standard preamplifier functions (volume +/-, mute, balance etc) can also be controlled, using the corresponding keys on the handset.

Note:

If your KNEKT RCU does not respond to the KNEKT commands from the remote control, please check firstly that the remote control handset is functioning (perhaps check it using another Linn product). If the handset is functioning but will not control the KNEKT RCU, it may be that the KNEKT RCU has been programmed so that its remote control sensor is disabled. Please consult your Linn Custom Installer.

KNEKT Multi-room

Owner's Manual 8