English KNEKT RCU operation
Display
Switching the KNEKT RCU on/off
To bring a KNEKT RCU in and out of standby:
Shows source currently playing – e.g. CD player
Shows the source’s | Shows what the left hand | |
current status – e.g. stopped | ||
|
Shows what the
right hand
does – e.g. plays
VOL | WHERE | WHAT | DO | ON/OFF |
●Press ON/OFF to take the KNEKT RCU in or out of standby.
To switch all the KNEKT RCUs in the system off:
If your KNEKT system is INTERSEKT ™ based, you may have the option, depending on how your KNEKT system has been programmed, to send
every KNEKT RCU in the system into standby simultaneously (global shutdown):
●Press and hold ON/OFF on any KNEKT RCU in the system until the display shows ‘off’ and starts to count down from 5 – 0. Continue to hold ON/OFF until the countdown from 5 – 0 is complete.
A typical example of the KNEKT RCU display is shown above to illustrate how a source product’s controls and current status are displayed (in this case, a CD player). The display will change to reflect the status of the system and what is being controlled at a particular time. What will be displayed is very much dependent on how your system was programmed. Your Linn Custom Installer will be able to help you with any aspects of the programming.
The KNEKT RCU’s functions are explained in more detail below.
Once the countdown is complete, all KNEKT RCUs in the system will then go into standby.
Notes:
Not available in all systems.
Releasing ON/OFF before the countdown is complete will not result in a global shutdown and only that KNEKT RCU will go into standby.
To switch KNEKT RCUs on after global shutdown:
●Press ON/OFF on each KNEKT RCU that you wish to bring out of standby.
KNEKT
Owner's Manual | 4 |