PROGRAMMING THE KB5000 KEYBOARD
The following procedure will show you how to program the KB5000 with standard (keyboard) alphanumeric characters. The keyboard can be programmed with either ASCII or Scan code information. The default mode is the ASCII code mode. The following procedure assumes both a KB5000 keyboard and a 101 keyboard are attached.
NOTE: To run this program you must exit windows completely. Do not shell out from Windows.
1.With the correct programming graphics present. Select the cell you want to program by using the arrow keys on the 101 keyboard. The Up and Down arrows will select the row while the Shift and either the Right or Left arrow key will select the column.
2.Enter your programming text via the 101 keyboard. Continue programming until all the keys are programmed. It is not necessary to program all the keys for the KB5000 to function properly. The
maximum number of alphanumeric characters that can be programmed for any one key is limited only by the memory left.
NOTE: The maximum number of alphanumeric characters that can be programmed per standard keyboard is 1856.
DATA TRANSFER MENU
Dos shell
File list (*.tpl)
Load file from disk
Read from keyboard
Save file to disk
Write to keyboard
Press ESC to Quit
3.Press F2 to call up the Data Transfer Menu. There will be several choices to choose from.
4.Type W to write the programmed data into the KB5000’s non volatile memory. A “Writing Data” screen will open showing the percentage of memory written. It will take approximately 7 seconds to copy the data into the keyboard.
10
