Logitech 900 manual Disassembly Procedure

Disassembly Procedure

. Remove the battery compartment cover. There are four screws in this area that need to be removed. Two are immediately visible on either side of the serial number sticker. Remove them with a small Phillips head screwdriver and set them aside. There are also two hidden screws under the sticker (if there is no sticker, all four screws are visible). To remove the sticker, use an x-acto blade or razor to get under- neath one of the corners and peel it up gently. Once you get it started, you can use tweezers or small pliers to peel it off. If you are careful, you can lift the sticker and still be able to re-apply it later. Remove the two screws and set them aside.

. Now it is time to remove the black ‘rubberized’ back plate. This looks like soft rubber but it is actually a hard piece of plastic. Start at the top using a small pry tool and pry up the left corner. Then, move to the top right corner and pry that up as well. Once the two top corners are free, you can move the pry tool to the middle and, like a lever, bury it deeply and pull gently forward, prying the back plate towards you. This is not an exact science and you may need to experiment and pry in a few different places. You may also pry at the sides and use your hands to keep the piece from locking itself back in its side groves. There is a tab in the middle/center of the plate that will offer some resistance so the plate may come free suddenly. The only thing you need to really be aware of is that, on some H900’s, there is a sticky piece of double-sided tape at the very bottom of the plate (just below the raised dot). So, if the plate seems to come free but appears stuck in this area, use your pry tool to ‘peel’ the plate off of the tape. Once the plate is off, we can move to the next step.

Page