. With the logic board face up, take the back cover plate (silver and black – not the ‘rubberized’ piece) and align it with the board. You can verify align- ment by seeing that the screw hole at the top left of the back cover is directly over the mounting post at the top of the logic board. The next part is a little tricky. What you want to do now is press the front and back pieces back together. So, holding the remote with both hands press the front and back pieces together starting at the top.
. Once the top has been engaged (even if not com-
pletely), turn the remote face up and continue pressing the front and back together – moving down towards the middle and then the bottom. You should hear and feel the locking tabs snapping together and engaging. Once you are done, inspect the edges very closely to see if a locking tab did not engage.
There should be no gaps between the back cover sides and the front cover and the surface of the touch screen should be virtually flush with the sil- ver sides. If you see any part that is raised or there is a gap at the sides, apply gentle but firm pressure at that point until the front and back covers snap together.
At this point, you can test the installation before going any further. Insert the battery and allow the remote time to
Page
