. Turn the remote so that the logic board is face up. There are three screws that need to be removed so that the front cover can be separated from the logic board. Two of the screws are near the bottom of the remote on either side and the third screw is almost
. Now, the only other thing that needs to be done before the logic board can be removed from the front cover is to unclip the touch screen ribbon cable. Flip the black connecting clamp up and back. Do it gently and carefully since it can some- times detach from the connector and be difficult to put back on. Slide the ribbon cable out.
. To remove the logic board, simply lift it up. It may stick a little at the top left where there is a ‘soft’ connection (a hole in the board with a mounting post through it). Just wiggle it a little and it will come free. Now, depending on how you grabbed it, only the logic board will come free, or the logic board and the plastic button guide template and/or the button pads. Either way, all these components simply go back together and sit on top of one another – no screws, glue, etc. If the plastic button guide sticks to the logic board when it comes out, or if it stays on top of the button pad, either way is fine. Just make sure that if you separate all the components that the plastic guide is
Disassembly is now complete!
Page