Installation (for qualified installers only) | 7 |
SAFETY NOTICE:
Please read this entire manual before you install and use yournew roomheater. Failure to follow instructions may result in property damage, bodily injury, oreven death. Contact local building orfire officials about restrictions and installation inspection requirements in yourarea.
Planning The Installation
We suggest that you have an authorized Travis Industries dealer install your fireplace insert. If you install the fireplace insert yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this fireplace insert and notify your insurance company before proceeding with installation.
Preparation for Installation
•Check for damage to the exterior of the fireplace insert (dents should be reported, scratches can be fixed by applying touch up paint).
•Check the interior of the firebox (replace cracked firebrick and make sure baffle is in place).
The fireplace insert can be lightened by removing the firebricks and baffle (pg 25) - replace before operation.
Additional Accessories Needed for Installation
1Door Shell Kit (Black 99300175 Brass 99300176 or Pewter 99300177 - see pg 29)
2 Surround Panels (see page 31)
Installation Considerations
Installation Type | Considerations | |
|
| |
Insert with Positive Flue (Full Reline) | • Provides best draft | |
(Page 12) | • Easiest to clean | |
| ||
|
| |
Insert with Direct Connect Flue | • Provides good draft | |
(Page 12) | • Requires fireplace | |
| ||
|
| |
Insert with Face Seal Connection | • Utilizes existing masonry fireplaces with cross section | |
(Page 13) | of 28" to 144" | |
• Provides marginal draft | ||
| ||
NOTE: Before installing verify with local building | • Easiest to install | |
officials that this type of installation is | • Requires the optional surround panels and insulation | |
approved in your area. | (see "Surround Panels" on page 31). |
© Travis Industries | 4041129 |
