Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove manual Specifications

6	Specifications
	Heating Specifications:
	Approximate Maximum Heating Capacity (in square feet)*	800 to 2,250 Sq. Feet
	Burn Rate (Pounds per Hour)**	1.7 to 5.5
	Maximum Burn Time on Low Burn**	47 Hours
	Hopper Capacity	80 Pounds

*Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is alsoaffected by the fuel size, quality, and moisture level.

**Small pellets will increase or decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on fuel quality may occur.

Dimensions:

This tab can be bent out and used to hang the scraper rod tool.

5-1/4"

	13"
32"	4"
	Diameter
	Exhaust

Air Inlet (1-3/4" Outside Diameter)

16-1/2"

9-1/4"

25"	23"
	Weight: 225 Lbs.

Electrical Specifications:

Electrical Rating	115 Volts, 3.6 Amps, 60 Hz
Watts During Start-Up Sequence	400 (approximately)
Watts During Operation	180 (approximately)

Fuel:

The unit is designed for wood pellets that comply with the standards set by the Association of Pellet Fuel Industry (density of at least 40 lbs. per cubic foot, 1/4" to 5/16" diameter, length no greater than 1–1/2", 8200 BTU's/lb., moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). If the fuel does not comply to this standard, the unit may not operate as designed.

N O T E: This heater may use alternative fuel if equipped with the multi-fuel fire pot and properly maintained. See the publication “Multi-Fuel Pellet Fire Pot” for requirements (available from your Travis Industries, Inc. dealer).

EPA Compliance:

This heater has been tested exempt from EPA Phase II Requirements by OMNI Test Labs.

Travis Industries 4050418 1 0 0 - 0 1 1 5 6