LOREX Technology Technical Specs DCP1000 Pan/Tilt Dome Camera, Setting the Camera Address

Step 2: Connecting the Camera to the VistaPro4 Digital Video Capture Card

ƒAt the location of the PC, plug the other end of the 65’ Camera DIN cable into the DIN port labeled “To Camera” found on the PT interface module.

ƒUsing the 7’ RS-485 Connection Cable, connect the end terminated with the DIN plug to the port labeled “To DVR” (next to the DIP switches) on the PT Interface module.

ƒOn the other end of the RS-485 Connection Cable, screw the single orange wire into the “TX +” terminal of the ACC-RS232, and the green wire to the “TX –” terminal.

ƒPlug the RCA jack (from the RS-485 Connection cable” into the desired Camera Input found on the VistaPro4 card.

ƒConnect the ACC-RS232 connector into an available DB9 Comm Port.

Step 3: Setting the Camera Address

ƒThe Dip Switch setting of the camera connected to the PT Interface must correspond to the RCA Camera Input of the VistaPro 4

TECHNICAL SPECS: DCP1000 Pan/Tilt Dome Camera

Image sensor	1/4" Color CCD
Active pixels	512(H) X 492(V)
Image sensor area	4.8(H) X 3.7(V) mm
Resolution	> 330 TV lines
Min. illumination	1 Lux (F2.0)
Video output	1.0V p-p (75 ohms)
Electronic iris	1/60 ~ 1/100,000 sec
Lens	3.6mm
Synchronization	Internal
Signal format	525 lines, 2:1 interlace
System connection	6 Pin Mini DIN jack
Power source	DC12V (from interface or controller)
Power consumption	MAX. 2.4W
Operating temperature	-10°C ~ +50°C
Dimension	126 X 107 mm
Weight	1Kg
Pan/Tilt speed	15° per second
Pan travel	355°
Tilt travel	80°

4