14-PEK KIT INSTRUCTIONS
(14’ PLUG EXTENSION KIT)
FOR
90Degree
Outside Corner
1
3FT.
SECTION
2
3FT.
SECTION
3
BOTTOM
SECTION 4
UNITS WITH TERMINAL BOARD
STEP #
1.Turn heater off following Section 3 in “Lighting Instructions” and allow to cool.
2.Turn off all electricity to heater.
3.Remove top louver assembly, fan shroud and fan blade.
4.Loosen two screws on romex connector.
5.Remove junction box cover plate.
6.Disconnect three power cord terminals and pull power cord out of top of heater.
7.Insert power cord provided in kit through romex connector and plug onto terminal board following wiring diagram found in lighting and operating instructions.
8.Tighten two screws on romex connector.
9.Replace junction box cover plate.
10.Replace fan blade, fan shroud and top louver assembly.
11.Snap 90 degree outside corner (Ref. 1) onto 3 foot section (Ref. 2) plastic raceway. Insert power cord and remove blue backing from adhesive strip on raceway and apply to side of heater.
12.Insert power cord into second
13.Cut
14.Plug power cord into wall receptacle.
15.Light the heater following lighting instructions.
| LENGTH OF BOTTOM |
| SECTION (REF. 4) |
MODEL NO. | PLASTIC RACEWAY |
DVCF40 | |
DVCF55 | 14 Inches |
DVCF65 | 14 Inches |
NOTE: Above lengths terminate approximately 2 inches above floor.
Page 15