3.Assembling the transducer. Once you determine the correct position for the ratchets, assemble the transducer as shown in the
following figure. Don't tighten the lock nut at this time.
Metal
Nut washer
Rubber | Metal washer |
washers | |
| Bolt |
Assemble transducer and bracket.
4.Drilling mounting holes. Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The transducer's centerline should be in line with the bottom of the hull. Don't let the bracket extend below the hull!
Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.
Drill the holes using the #29 bit (for the #10 screws).
Transom
Transom |
Position transducer mount on transom and mark mounting holes.
Side view shown at left and seen from above at right.
5.Attaching transducer to transom. Remove the transducer from the bracket and
7
