Lowrance electronic X47EX manual 146.5, Millimeters Inches, For

146.5

[5.76]

Top

R 7.9 [0.31]

In-Dash

Template

113.5

[4.46]

Millimeters

[Inches]

ALWAYS VERIFY DIMENSIONS

In-dash mounting template for X47EX, showing dimensions. NOTE: The preceding figure is not printed to scale. A scaled template is available for free download from our web site, www.lowrance.com.

For the X47

The X47 can be mounted in-dash using the removable scaled template inside the back cover of this manual (page 43). The FM-6 mount kit includes the necessary materials, but the instructions only appear here in this manual.

Please read all the instructions before proceeding. NOTE: Recommended

tools for this job include: jig saw, drill, drill bit (for starting hole).

1.Select the desired mounting location. Make sure there is enough room behind the dash to attach the unit's cable. The case is approximately 1-3/4" (45 mm) behind the mounting surface. You also need to allow an additional 1" (25 mm) for the power/transducer cable and connector.

2.Cut or tear out the template in the back of this manual (page 43) and tape it to the dash. Begin the cutout by drilling a starter hole near the center of the template. Use a drill bit big enough for the jigsaw blade.

3.Slip your saw blade into the starter hole and then cut along the outside line. Be careful when working around the corners, because there is little room for error.

4.Remove the backing from one side of the double-sided mounting tape contained in the mounting kit. Apply it to the outer ledge on the back of your unit. Starting at the bottom center, work the tape around all four sides of the unit. Cut off any excess tape when finished.

5.Attach the power/transducer cable to the back of the unit.

15