Table A.3 High-Density 68-Pin Connector Pinout (SE SCSI)

 

Connector

Cable

 

Cable

Connector

 

Signal

Pin

Pin

 

Pin

Pin

Signal

 

 

 

 

 

 

 

Ground

22

43

 

44

56

FAULT_DATA H

 

 

 

 

 

 

 

Ground

23

45

 

46

57

-BSY

 

 

 

 

 

 

 

Ground

24

47

 

48

58

-ACK

 

 

 

 

 

 

 

Ground

25

49

 

50

59

-RST

 

 

 

 

 

 

 

Ground

26

51

 

52

60

-MSG

 

 

 

 

 

 

 

Ground

27

53

 

54

61

-SEL

 

 

 

 

 

 

 

Ground

28

55

 

56

62

-C/D

 

 

 

 

 

 

 

Ground

29

57

 

58

63

-REQ

 

 

 

 

 

 

 

Ground

30

59

 

60

64

-I/O

 

 

 

 

 

 

 

Ground

31

61

 

62

65

-DB(8)

 

 

 

 

 

 

 

Ground

32

63

 

64

66

-DB(9)

 

 

 

 

 

 

 

Ground

33

65

 

66

67

-DB(10)

 

 

 

 

 

 

 

Ground

34

67

 

68

68

-DB(11)

 

 

 

 

 

 

 

The following applies to the high-density SCSI connector described in Table A.3:

￿A hyphen before a signal name indicates that signal is active low.

￿The connector pin refers to the conductor position when using 0.025 inch centerline flat ribbon cable with a high-density connector (AMPLIMITE.050 Series connectors).

￿Eight-bit devices connected to the P-Cable must leave the following signals open: -DB (8), -DB (9), -DB (10), -DB (11), -DB(12), -DB (13), -DB (14), -DB 15), and -DB (P1).

￿All other signals should be connected as defined.

Caution: Lines labeled RESERVED should be connected to Ground in the bus terminator assemblies or in the end devices on the SCSI cable. RESERVED lines should be open in the other SCSI devices, but can be connected to Ground.

A-8SCSI Cables and Connectors

Copyright © 2002 by LSI Logic Corporation. All rights reserved.