6.2.1Step 1: Unpack

Unpack and install the hardware in a static-free environment. Remove the MegaRAID SCSI 320-1 controller card from the anti-static bag and inspect it for damage. If the card appears damaged, or if any item listed below is missing, contact LSI Logic or your MegaRAID OEM support representative. The MegaRAID SCSI 320-1 controller is shipped with the following:

￿The Driver and Documentation CD, which contains these items:

–The MegaRAID Configuration Software Guide

–The MegaRAID Operating System Driver Installation Guide

–The MegaRAID SCSI 320-1 Hardware Guide

–The software license agreement

–The MegaRAID SCSI 320-1 configuration utilities for DOS

￿The warranty registration card

6.2.2Step 2: Power Down

Turn off the computer, remove the power cord, then remove the cover. Make sure the computer is turned off and disconnected from any networks before installing the controller card.

6.2.3Step 3: Check Jumper Settings

Make sure the jumper settings on the MegaRAID SCSI 320-1 card are correct. The jumpers are set at the factory and you probably do not need to change them. Table 6.2 lists the jumpers (and a connector).

Table 6.2

Jumpers for the MegaRAID SCSI 320-1

 

 

 

 

Item

Description

Type

 

 

 

 

 

J2

Dirty cache LED

2-pin header

 

 

 

 

 

J3

Clear EPROM

2-pin header

 

 

 

 

 

J4

BIOS enable

2-pin header

 

 

 

 

 

J5

SCSI activity LED

2-pin connector

 

 

 

 

 

J6

Serial port

3-pin header

 

 

 

 

 

Installation Steps

6-3

Copyright © 2002 by LSI Logic Corporation. All rights reserved.