2.2.2 Inserting the Host Adapter

For safe and proper installation, you will need the user’s manual supplied with your computer for reference. Perform the steps listed below to install the SYM8953U.

Step 1. Ground yourself before removing this host adapter board.

Step 2. Remove the SYM8953U PCI to Ultra2 SCSI Host Adapter board from the packing and check that it is not damaged.

An example of this host adapter board is shown in Figure 2.1.

A more detailed drawing is located in Figure A.1.

Step 3. Switch off the computer and unplug power cords for all components in your system.

Step 4. Remove the cover from your computer per the instructions in the user’s manual for your system to access the PCI slots.

Caution: Ground yourself by touching a metal surface before removing the cabinet top. Static charges on your body can damage electronic components. Handle plug-in boards by the edge; do not touch board components or gold connector contacts. The use of a static ground strap is recommended.

Step 5. Locate the slots for PCI plug-in board installation.

Refer to the user’s manual for your computer to confirm the location of the PCI slots.

Important: The SYM8953U board requires a PCI slot that allows bus master operation.

Step 6. Remove the blank bracket panel on the back of the computer aligned with the PCI slot you intend to use.

Save the bracket screw.

2-4

Installing the SYM8953U Host Adapter

Page 20
Image 20
LSI SYM8953U manual Inserting the Host Adapter