Most PC cabinets are designed with a front panel LED. You may connect the LED cable to connector J4 on the host adapter, as shown in Figure 2.8. This causes the front panel LED to light when there is activity on the SCSI bus.

Connector J4 is not keyed. The orientation of the LED cable does not matter as long as all four pins are connected.

Figure 2.8 SCSI LED Connector

LED

Connector

J4

Some LED cables have only two wires. In this case, place the connector on one end or the other of J4. If the LED does not light during SCSI bus activity from this host adapter, you may have to rotate the LED cable connector 180° on J4.

2-14

Installing the LSIU80ALVD