Batteries and chargers
7.3 | Dual Chargers |
The Dual Charger is a
Place the handset face forward into the Dual Charger front slot. Place a spare Battery Pack in the rear slot, charging contacts down. The front slot takes charging precedence. The Battery Pack in the rear slot will begin charging when the handset in the front slot is fully charged or when the front slot is empty.
Indicator light
An LED on steady indicates that the spare battery is charging. A flashing LED indicates spare battery charging malfunction (insert the spare battery again or change it). When the LED is off, this means that the charging of the spare battery has terminated, that the compartment is empty or that the charger is not connected to the mains.
Charge Complete
When the IP Touch WLAN is fully charged, Charge Complete will display.
7.4 | The Gang Charger - only on Mobile IP Touch 610 WLAN |
The Gang Charger is designed to charge four Battery Packs simultaneously. Chargers operate in a 50° to 85° F (10° to 30° C) environment. Do not expose them to freezing temperatures or direct sunlight.
The Gang Charger is shipped with the appropriate power supply for the site’s location. Place the Gang Charger on a flat, horizontal surface. Plug the power supply into the Gang Charger and into an appropriate wall outlet.
Using the GC
Insert the Battery Pack into one of the four charging bays so that the Battery Pack contacts meet the charging bay contacts. The LED above the charging bay will turn on to indicate that charging is in progress. When charging is complete the LED will turn off. Lift the Battery Pack out of the charging bay.
Blinking LED
If the LED starts blinking as soon as the Battery Pack is inserted, the Battery Pack may be improperly seated. Lift it out and reinsert. If the LED continues to blink or starts blinking at any time during the charging process, it indicates that there is a problem with the Battery Pack that makes it unusable. Do not continue to charge the Battery Pack. Dispose of it properly and do not attempt to use it in the IP Touch WLAN. Do not attempt to open or repair a defective Battery Pack. Contact your service representative for assistance. If the LED is on steady, this means the charger is defective. Contact your administrator.
7.5 | Cleaning the Chargers |
Clean the Chargers by wiping the surface with a clean,
The Battery Pack contacts on the IP Touch WLAN may be cleaned with isopropyl (rubbing) alcohol applied with a
•Important information
•Never use
•Only use the original
•Do not immerse the Battery Pack in water or throw into the fire.
•Do not throw away the Battery Pack with your domestic waste. Take used Battery Packs to an appropriate collection point for recycling or send them back to your supplier or servicing agent.
•Replacement Battery Packs are available from your supplier or servicing agent.
24 |
