![](/images/new-backgrounds/1236446/236446147x1.webp)
DEFINITY Communications System | APPENDIX B: |
7400B Data Module |
|
User’s Guide | Page |
|
|
Register:
Description:
Range of
Values:
Storable:
Comments:
See Also:
S14
This
bit 0 — not used (always set to 0)
bit 1 — 0 = command echo disabled, 1 = command echo enabled (default = 1, see E command)
bit 2 — 0 = result codes enabled, 1 = result codes disabled (default = 0, see Q command)
bit 3 — 0 = short result codes, 1 = verbose result codes (default = 1, see V command)
bit 4 — not used (always set to 0)
bit 5 — 0 =not used (see comment 1)
bit 6 — not used (always set to 0)
bit 7 — 0 = originate mode, 1 = answer mode (default = 1, see A and
Dcommands)
Value may be 00 to FF hexadecimal;
yes
1.In the DCP operating environment of the 7400B Data Module, tone and pulse dialing have no meaning. If the T or P dial modifiers are used, bit 5 is changed accordingly, but the data module performs no other action.
2.Refer to the explanation of hexadecimal values under the Range of Values label description at the beginning of this appendix.
Chapter 4, “Operation and Configuration”; refer to the indicated AT commands in Appendix A, “AT Command Set.”
Register: | S15 — not used |
|
|