Lucent Technologies Host-Based Controller Modem AT Comma Dial Modifier Time, S10, S11

0—65

2 seconds

Automatic Disconnect Delay

Data Addendum		Host-Based Controller Modem
June 15, 1998		AT Command Set
AT Commands Reference S-Registers (continued)
S8	Comma Dial Modifier Time

This register sets the time, in seconds, that the modem must pause when it encounters a comma (,) in the dial command string.

Range:

Default:

Units:

S10

This register sets the length of time, in tenths of a second, that the modem waits before hanging up after a loss of carrier. This allows for a temporary carrier loss without causing the local modem to disconnect.

The actual interval the modem waits before disconnecting is the value in register S10.

Range:	1—254
Default:	20
Units:	.1 seconds
S11	DTMF Dialing Speed

This register determines the dialing speed which is prefixed for each country.

Range:	50—150
Default:	95
Units:	.001 seconds
S12	Escape Guard Time

This register sets the value (in 20 ms increments) for the required pause after the escape sequence (default 1 s).

	Range:	0—255
	Default:	50
	Units:	.02 seconds
S14	General Bit Mapped Options Status

Indicates the status of command options. Only bit 3 and bit 6 are used, read-only.

Bit 3	Result codes (Vn)
0 = Numeric (V0)
1	= Verbose (Vl) (Default)
Bit 6	Pulse dial PPS selection (&Pn)
0	= 10 PPS (&p0, &p1) (Default)
1	= 20 PPS (&p2)
Default:	8 (00001000b)

Version 1.0 Lucent Technologies Inc. 31