Advanced setup
The sub menus accessible in the Advanced menu are:
Advanced setup
|
|
|
|
|
|
|
|
|
| Communication |
|
| Routing |
|
| Delay |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Master/Slave |
|
| Crossover freq. |
|
| Trigger setup |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Line Out |
|
| Filter Type |
|
| Remote Control |
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Communication
The sub menus accessible in the Communication menu are:
Software versions
Factory Reset
Communication
Comm Address
Comm Speed
Comm Address
The Communication Address setting identifies the TDAI 2200’s to the PC interface or other Lyngdorf products. In master mode the amplifier setting is normally 1, and the addresses
Comm Speed
The Communication Speed setting is the RS232 Link interface speed. The default setting is 57600 baud. With different PC’s and different lengths of cables the settings can be changed to 9600 or 115200 baud. If a
Master/Slave
Master/Slave
As default a TDAI 2200 is set as a Slave. The Master setting should be used if you are using two TDAI 2200, e.g. for
25