Lyngdorf Audio TDAI 2200 owner manual Delay, Trigger Setup

Delay

Delay

If you are using a set-up with two main loudspeakers located at an identical distance to the listening position you don’t need to set a delay. However, if the distance isn’t identical and/or you are using a sub- woofer, or a Lyngdorf Audio 2+2 system, you need to set a delay in order to ensure that the sound from each loudspeaker reaches the listening position simultaneously. This must be done for main left (ML) and right (MR) and as well as line left (LL) and right (LR).

To set the delay all you need do is to measure the distance from each loudspeaker to the listening posi- tion and enter these values in the menu. The necessary delays are then automatically calculated and applied to each channel.

1 centimeter = 0.3937 in

The fault message ‘Values for delay exceed limits’ is displayed when the difference between the distance from the speakers closest to, and the speakers furthest from, the listening position is too big. The biggest difference allowed is 340 cm / 134 in.

If the fault message appears, you can use the following solutions:

(Can be used individually or together to achieve a valid set-up with respect to the delay lengths):

•Shorten the distances between your Main and Line channel loudspeakers resulting in a more compact loudspeaker set-up.

•Arrange your loudspeaker set-up and/or your listening position in a more symmetrical set-up.

Trigger Setup

Trigger setup

Trigger setup sets the usage of the trigger output option. If e.g. an SDA2175 is connected to drive a sub- woofer from the Line out, the trigger can be activated and used for switching the SDA2175 on and off.

28