M&S Systems MNCXS owner manual

Page 8 MNCX/MNCXS Owners Manual

5.Tighten the “knurled” nut (A) using a crescent wrench until it is firmly seated against the back of the speaker and has fully locked the ball/shaft (C) and the speaker cabinet together. Please note that once the nut is tightened, it may embed some marks on the back of the speaker where the attachment is made. The nut

(A)will cover these marks.

6.Feed the speaker wire through hole (M) on the wall bracket (D).

7.The safety cord (H) is provided to prevent the speaker from falling. One of the two lower screws (I) that attach the wall bracket (D) to the wall will need to go through the eyelet (K) at the end of the cord before going through the wall bracket hole. Mount the wall bracket

(D)onto a wood stud in the wall, using #10 screws that are a minimum of 1 ¼” long. Make sure that all 4 screws are driven into the stud and not in drywall. If the bracket needs to be mounted on drywall, the use of properly selected and installed wall-anchors and screws is essential. Make sure that the screw head is at least 0.36 inches (approximately 3/8 inches) or larger in diameter so that it can properly hold the backup cord eyelet (K).

8.Holding the speaker cabinet (G) with both hands, reinsert the ball portion of the ball/shaft (C) into the wall bracket (D).