Page 6 | MNCX/MNCXS Owners Manual |
|
The MNCX unit is designed with a swivel joint between the two speakers allowing each speaker to be individually aimed. The unit also comes with a mounting bracket for attachment to a wall or ceiling. The bracket screws into the threaded socket on the back of the top speaker, and may be adjusted so that the speakers point in the desired direction.
Mounting Your Speakers
Important Safety Note: Proper selection of mounting hardware not included herein and proper assembly and installation of brackets, including but not limited to selection of appropriate weight bearing support and bracket use with the specified speaker only is the exclusive responsibility of the customer. M&S Systems disclaims any liability for the selection of mounting hardware and/or proper bracket installation.
Please follow the instructions below and refer to the diagram when mounting the MNCX
1.Loosen and remove the molded nut (B) by turning it counter clockwise. Use the supplied metal bar (E) if necessary by inserting it in one of the holes on the molded nut (B).
