Mabe Canada JGBP86 installation instructions Burner Caps and Heads

Care and cleaning of the range.

Burner cap is	Burner cap is NOT
properly seated.	properly seated.

Burner bases (on some models)

Burner Caps and Heads

Before removing the burner caps and heads (on some models), remember their size and location. Replace them in the same location after cleaning.

NOTE: Do not use steel wool or scouring powders to clean the burner parts.

Burner caps

Lift off when cool. Wash burner caps in hot, soapy water and rinse with clean water. You may scour with a plastic scouring pad to remove burned-on food particles.

Burner Bases (on some models)

The round burner bases are not removable. Only the caps may be removed for cleaning.

Replacement

Burner Heads (on some models)

Replace burner heads over the electrodes on the cooktop, in the correct locations according to their size. There is one small, one medium, one large and one extra large burner head.

Medium head Small head

Large head		Extra large head
	Front of range

The burner bases (on some models) are not removable. Only the caps may be removed for cleaning.

To clean the burner bases, use soapy water and a plastic scouring pad. Wipe clean with a damp cloth.

Make sure that no water gets into the burner bases. Allow them to dry fully before using.

Make sure the slot in the burner head is positioned over the electrode.

Electrode Slot

Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

Burner heads (on some models)

Slot

Electrode

The burner heads (on some models) are removable. Simply lift them off the range for cleaning.

Hole in burner head

Burner Heads (on some models) and Oval (Center)

Burner Head/Cap Assembly

The burner heads and the oval burner head/cap assembly are removable. Simply lift them off the range for cleaning.

For proper ignition, make sure the small hole in the section that fits over the electrode is kept open. A sewing needle or wire twist-tie works well to unclog it.

The slits in the burner heads must be kept clean at all times for an even, unhampered flame.

Clogged or dirty burner ports or electrodes will not allow the burner to operate properly.

Any spill on or around an electrode must be carefully cleaned. Take care to not hit an electrode with anything hard or it could be damaged.

Clean the burner heads routinely, especially after bad spillovers, which could clog the openings.

Oval (Center) Burner Head/Cap Assembly

Replace the oval (center) head/cap assembly over the electrode on the cooktop.

Oval head and cap	Make sure the slot in the
assembly
	burner head is positioned
	over the electrode.

Slot

Front of range Electrode

Caps

Replace the matching size caps onto the burner bases or heads.

Support

The oval burner head/cap assembly is removable. Simply lift it off the range for cleaning. Use a sewing needle or twist-tie to unclog the small hole in the burner heads.

Lift off when cool.

To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20–30 minutes. For more stubborn stains, use a toothbrush.

Medium cap

Large cap

Small cap

Extra large cap

Consumer

	After cleaning
	Before putting the burner caps, heads
	(on some models) and oval head/cap assembly
	back, shake out excess water and then dry them
	thoroughly by setting in a warm oven for 30
36	minutes.

Front of range

Make sure that the heads (on some models) and caps are replaced in the correct locations.