Console

Appendix D: Transform Switch Rotation and Fader Replacement

d.2 Pro DJ Production

Transform Switch Rotation

From the factory, the transform switches operate vertically, that is (to get all technical for a moment) fore and aft.

You can perform a simple modification to make these switches operate sideways, or even diagonally, to suit your carefully cultivated set of operational preferences.

Tools

To do this procedure, you will need a small phillips screwdriver, nerves of steel, grit, determination, and a steady hand. People should find you ruggedly charming, yet approachable.

Procedure

1.Remove the power cord, and any other cords or cables connected to the d.2 Pro.

2.Gently place the d.2 Pro face upwards on a flat, clean and dry surface, such as the kitchen table.

3.Remove the three slider knobs, by gently pull- ing them upwards. Keep them safe.

4.Undo the five screws from the top panel and two screws from the front, as shown. Keep the screws in a safe place.

PGM 1

 

PGM 2

TRANSFORM

 

TRANSFORM

 

MAIN

 

 

L R

 

OL

OL

OL

10

10

10

7

7

7

4

4

4

2

2

2

0

0

0

2

2

2

4

4

4

7

7

7

10

10

10

20

20

20

30

30

30

REVERSE

REVERSE

REVERSE

 

A

B

5.Gently lift off the panel, taking care not to dam- age the front panel contour knobs. Keep it in a safe place were it won’t get scratched, or fall off the table.

6.Each transform switch has

four screws, but remove only the outer two. These are black, whereas the inner

screws are bright and shiny.

7. Rotate the switch assembly

to suit your preference, and replace the two screws.

Diagonally Sideways

8.If you need to replace a transform switch, gently pull it out just enough so you can reach and undo its connector. Connect the new switch securely, and screw it in the desired position. You might want to replace both switches, if they are both aged and/or had a rough life.

9.Replace the top cover, and make sure that all the meter LEDs and the Reverse LEDs are pok- ing through before you tighten down the screws securely.

PGM 1 FADER

CROSS FADER

PGM 2 FADER

REVERSE

REVERSE

REVERSE

SLOW

FAST

SLOW

FAST

SLOW

FAST

CONTOUR

CONTOUR

CONTOUR

24

d.2 Pro DJ Production Console