
Locate Points and Looping
Locate points provide fast access to frequently used locations in your Project. The MDR24/96 has two numbered Locates (two additional numbered Locates are availible when using the Remote 24 or Remote 48). Storing a Locate point saves the Current Time (Transport position) to the Locate button. Recalling a Locate causes the Transport to jump to the stored time.
To recall a Locate point:♦ Press Loc 1 or Loc 2 to jump to that point.
LOC 1 | LOC 2 |
|
| ||
|
|
|
|
|
|
Locate points can be stored either on the fly or when stopped.
1.Press Store. The Store light will blink to indicate that the MDR24/96 is ready to save a Locate point.
2. Press Loc1 or Loc 2 when the Transport is at the |
|
desired time; the Store light will go out, indicating that |
|
the point has been stored. | LOC 1 LOC 2 STORE |
Locates 1 and 2 double as start and end points for looped playback. When looping is enabled, playback cycles between the Loop Start and Loop End points. The order of the Loop points does not matter. If Current Time is outside the Loop points when playback starts, the transport jumps to the Loop Start point; if it is between the Loop points, playback starts from Current Time.
To enable Looping:1. | Press Loop |
|
|
| |
|
|
| |||
2. | Press Play to start loop playback. |
|
|
| |
LOOP |
|
| |||
|
|
|
|
|
Start Quick Guide
|
|
Quick Start Guide | 29 |
|
|