Magnat Audio MC 1 manual Before Starting, Important Safety Precautions, Instructions for Disposal

GB

BEFORE STARTING

Dear customer,

Thank you for choosing the Magnat MC 1 SACD/CD Receiver.

Please read the following information carefully before starting to use the MC1.

IMPORTANT SAFETY PRECAUTIONS

• Please read the instruction manual carefully before use and keep it in a safe place
• This device is only intended for use with 230 V/50 Hz AC voltage.
• Only operate the device at an ambient/room temperature between 0°C and 40°C..
• Make sure there is sufficient ventilation for the device. There must be a minimum gap of
10 cm between objects to the side, to the rear and above the device:
10 cm
10 cm	10 cm
• The ventilation slots should not be covered by any items (e.g. curtains, newspaper, etc.)
in order to ensure sufficient ventilation for the device. Please do not position any sources
of heat, such as radiators, ovens, naked flames or other devices that generate heat in
close proximity to the device.
• The device and the remote control should not be exposed to dripping or splash water or
high levels of humidity.
• No objects filled with liquids, such as vases, shall be places on the unit.
• In the event of contact with moisture or liquids remove the mains adapter immediately.
• Only clean the device using a dry cloth.
• Do not use any cleaning agents or chemical solvents when cleaning, as these could
damage the surface of the device.
• Never open the device.
• The mains cable must always be operational. The device should not continue to be
operated if there is visible damage to the mains cable. A damaged cable should not be
repaired, but must be replaced.
• Do not connect or remove the mains cable with damp hands.
• Always refer to a qualified specialist for any maintenance or repair work.
• If the device is not going to be used for a prolonged period, switch it off by using the power
switch (2) located on the rear of the device (see the section entitled "Rear/connections").
• Please remove the mains plug in the event of thunderstorms.

•Only connect the device using a 3-pin power cable with ground wire (earth)! This is part of the original accessories. Only use this original accessory for the power supply or a power cable that has been examined with regards to its safety (e.g. with a TÜV or VDE certificate).

•The safety function of the power cable's earthed plug should not be impaired in any way. The earthed plug has two contacts as well as a protective earth contact (i.e. a total of 3 contacts). The protective earth contact is important for operational safety and it must be in contact with the protective earth contact of the wall socket which supplies the device with electricity. If the earthed plug of the supplied power cable is not applicable with the socket (power supply) in your country, please refer to a qualified technician to exchange the cable.

This symbol warns the user that high voltage is used within the device which can result in electric shock.

This symbol makes the user aware that there are important notes in the enclosed instruction manual which must be observed.

Warning:

Do not open! Risk of electric shock!

To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture.

This symbol informs the user that there is a class 1 laser operating inside the device which does not pose any hazardous threat outside the device.

INSTRUCTIONS FOR DISPOSAL

In accordance with European Directive 2002/96/EC all electrical and electronic appliances must be disposed of separately via local collection points. Please observe the local regulations and do not dispose of your old appliances with normal household waste.

12