GB
SLEEP FUNCTION
This function enables you to set a time after which the device will switch off automatically and change to the standby mode.
•Press the SLEEP button on the remote control. The following appears in the display:
•Press the SLEEP button again and the following will be displayed:
90min. Sleep mode
•You can reduce the
•After the time has been set the display automatically reverts back to its previous status. However, confirmation that the sleep mode is active is visible in the display.
OTHER IMPORTANT INFORMATION
Headphones
•You can connect headphones with a 3.5 mm stereo jack to the socket located on the front of the MC 1.
•Before doing this set the volume to VOL 00.
•The sound from the speakers is automatically disconnected when headphones are inserted.
•Please note that listening to music at high volume via headphones can cause irreparable damage to your hearing!
Line in (front panel)
• This is used for connecting an audio source with a 3.5 mm stereo jack.
The other analogue connections on the rear of the MC 1 are designed for RCA cables.
If you should have any further queries, please refer to the operating instructions for the respective device.
Phono input
The MC 1 has a high quality phono preamplifier with RIAA equalisation. Only record players with a magnetic system (MM) or a moving coil system with high level output (high output MC) may be connected here.
Most of these devices have an additional earth wire. Please connect this to the rear of the MC 1 using the screw (10) in order to minimise the degree of humming.
SPECIFICATIONS
Amplifier |
|
|
|
|
Power output: |
|
|
|
|
Rated power | 20 Hz – 20 kHz, THD < 1.0%, 4 ohm | 2 x | 80 w | |
| 20 Hz – 20 kHz, THD < 1.0%, 8 ohm | 2 x | 60 w | |
Pulse power | 1 kHz, 4 ohm |
| 2 x 150 w | |
Frequency response: | 5 Hz – 100 kHz |
|
| |
|
|
| ||
| 20 Hz – 20 kHz |
|
| |
Phono | 20 Hz – 20 kHz |
|
| |
Signal to noise ratio: |
|
|
|
|
CD/Aux/Line/Tape | 95 dB |
|
|
|
Phono | 85 dB |
|
|
|
Input sensitivity/impedance: |
|
|
|
|
AUX/Line/Tape | 250 mV/33 kOhm |
|
|
|
Phono | 5 mV/47 kOhm |
|
|
|
Equalisation: |
|
|
|
|
Bass | ±10 dB/100 Hz |
|
|
|
Treble | ±10 dB/ 10 kHz |
|
|
|
FM Tuner |
|
|
|
|
Frequency response: | 87.5 – 108 MHz |
|
|
|
Signal to noise ratio: |
|
|
|
|
Mono | 75 dB |
|
|
|
Stereo | 70 dB |
|
|
|
Harmonic distortion: |
|
|
|
|
Mono | <0.25% |
|
|
|
Stereo | <0.50% |
|
|
|
AM Tuner |
|
|
|
|
Frequency response: |
|
|
| |
Signal to noise ratio: | 40 dB |
|
|
|
Miscellaneous |
|
|
|
|
Dimensions (wxhxd): | 360 x 110 x 400 mm |
|
|
|
Weight: | 8.9 kg |
|
|
|
Electricity consumption:: |
|
|
|
|
Max | 200 W |
|
|
|
Standby | 1.4 W | Subject to technical change. | ||
18
