12
WATCHING TV
Sleep Timer
can set the unit to go into standby mode after an incremental period of time.
Press SLEEP repeatedly to change the amount of time (increases |
|
|
Sleep | 120min. | |
the time by 30 minutes up to 120 minutes). |
|
|
Press SLEEP once to call up the display for checking the remaining time.
• To cancel sleep timer, press SLEEP repeatedly until [Sleep Off] is displayed.
Switching Each Input Mode can easily switch with the remote control between TV (ATSC or NTSC) and external devices when they are connected to the unit.
Press SOURCE or CH + repeatedly to cycle through the input modes.
Source
TV
HDMI
Video
PC
e.g.) |
|
|
| ||
|
|
| HDMI |
| Video |
|
|
|
| or | |
| 11.1 |
|
|
| |
| DTV /TV channel |
|
|
| |
| PC |
| Component | ||
|
|
|
|
•Pressing CH − reverses the direction of the input modes.
*[Component] will be displayed if you connected component video cables to this unit.
Freeze Mode can freeze the image shown on the TV screen for 5 minutes.
Press FREEZE to freeze the image.
Freeze
•The sound output will not be paused.
•To cancel freeze mode, press any buttons except .
Channel Selection
Select channels by using CH +/− or the Number buttons.
• To select the memorized channels, use CH +/− or the Number buttons.
• To select the
To use the Number buttons
ATSC
-When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
NTSC
-When selecting cable or analog channel 11
Press PREV CH to return to the previously viewed channel.
Note | • | [No Signal] will appear on the TV screen after the subchannel |
|
| broadcast is over. |
| • | [Audio only program] message will appear on the TV screen, when you |
|
| receive only sound signal. |