Supplied Accessories
Owner’s Manual | Quick Start Guide Registration card |
Quick
Start
Installation
Installation
Instalación
Best
Better
Good
TV base and 2 screws (M4 x 14)
Remote Control (NF805UD) Batteries (AAA, 1.5V x 2)
AAA
AAA
Note
•If you lose the screws, please purchase M4×14 Phillips head screws at your local store.
•If you need to replace these accessories, please refer to the part name or No. with the illustrations and call our toll free customer support line found on the cover of this manual.
When using a universal remote control to operate this unit.
•Make sure the component code on your universal remote control is set to our brand. Refer to the manual accompanying your remote control for more details.
•We do not guarantee 100% interoperability with all universal remote controls.
Symbols Used in this Manual
The following is the description for the symbols used in this manual. Description refers to:
ATSC : Digital TV operation
NTSC : Analog / Cable TV operation
•If neither symbol appears, the operation is applicable to
both.
English
Attaching the Base
You must attach the base to the unit to have it as a table top unit. Be sure the front and rear of the base match the proper direction.
1 Check the text “FRONT” with “arrow“ on the Base’s bottom to ensure it is being installed in the correct direction. Spread a thick and soft cloth over a table as shown at step 2. Place the main unit face down onto it. Make sure not to damage the screen.
2 Insert hook under the |
|
bottom of the main | ➁ |
unit into base hole |
|
(shown by arrow ➀), |
|
then move the base in | ➀ |
the direction as shown | |
by arrow ➁ until it | FRONT |
stops and the screw |
|
hole is aligned.
Make sure not to put the AC power cord between the base and the unit.
3 Drive Phillips head screws into the 2 threaded holes at the bottom of the base until they are tight.
To remove the base from this unit
•Unscrew the Phillips head screws in step 3.
After the screws are removed, pull the base up toward the rear of the unit. Be careful not to drop the base when you remove it.
Note
•When attaching the base, ensure that all screws are tightly fastened. If the base is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.
•Make sure to use a table which can support the weight of this unit and is larger than this unit.
•Make sure the table is in a stable location.
•When attaching the base, ensure that “FRONT” with “arrow” written on the bottom of the base is downward. If it’s not downward, the hook doesn’t fit into the base.
Mounting the Unit on Your Furniture
Screw this unit on your furniture tightly using wood screws (not supplied) in the 2 holes at the back of the base as shown.
•Recommended screw dimension : 3/16 x 3/4 inches (5.1 x 20 mm) rear of this unit
screw hole
Note
•When you remove this unit make sure to unscrew the wood screws from your Wood Stand, Furniture and other wood item.
7
INTRODUCTION PREPARATION WATCHING TV USING FUNCTIONS CONNECTING DEVICES USEFUL TIPS INFORMATION