38 Timer Recording With the VCR Plus+ Programming System
Follow the steps below to program a timer recording using the PlusCode programming numbers in your TV guide. Before you begin, make sure:
●The clock has been set. If not, CLOCK MUST BE SET appears.
● Channels are programmed. | 3 |
| |
● There is a tape in the TV/VCR (make sure the tape’s record tab |
|
is intact and the tape is long enough to record the program). |
|
● You have completed the steps on pages |
|
Complete each step within 60 seconds of completing the previous step. If you don’t, you may return to step 1.
1
POWER
1 2
4 5
78
0
SPEED
–REW
SLEEP
ALT.CH
3
6o
CHANNEL
9p
+100 o
MUTE | VOLUME |
p
o
PLAY
F.FWD +
2
Press the VCR PLUS+ button on the remote control. The on- | STOP |
|
screen display shown below will appear. | p |
|
REC/OTR MEMORY PAUSE/STILL VCR PLUS+ | ||
VCR PLUS+ PROGRAM | MENU STATUS/EXIT CLEAR | SOUND |
|
| SMART |
PLUS CODE : – – – – – – – –
1
TO END PRESS EXIT
2
Press the Number buttons to enter the PlusCode pro- gramming number of the program you wish to record (this number is different for every program, and it can be four to eight digits long). Finally, press the VCR PLUS+ button.
VCR PLUS+ PROGRAM
PLUS CODE : 60590 – – –
TO SET PRESS VCR +
TO CORRECT PRESS CLEAR
TO END PRESS EXIT
3
To record the program once, press the Number 1 button to select ONCE. To record the same program every day from Monday through Friday, press the Number 2 button to select DAILY. To record the same program every week on the same day (such as every Saturday), press the Number 3 button to select WEEKLY.
VCR PLUS+ PROGRAM
1ONCE
2DAILY (MON - FRI)
3WEEKLY
TO SELECT PRESS NUMBER
TO END PRESS EXIT
Helpful Hints
•If the power fails, programmed timer recordings will be lost.
•You cannot set a timer recording if the TV/VCR is in Record Defeat mode. To set the Record Defeat mode to OFF, see page 40.
•If CODE ERROR flashes after you enter the PlusCode programming number and press the VCR PLUS+ button, the number you entered was incorrect (for example, too short). If this happens, enter the correct num- ber.
•CLASH may flash on the screen after you complete step 2. This means that the timer recording you just pro- grammed and another timer record- ing overlap, and thus the current timer recording will not be carried out.
