Magnavox CCX133AT99 warranty Turning On the TV/VCR

8 Turning On the TV/VCR

Before you turn on the TV/VCR, make sure there are batteries in the remote control (details are on page five) and the TV/VCR is hooked up correctly (details are on pages six - seven).

The instructions on this page work only when you turn on the TV/VCR for the first time.

1

Press the POWER button. The TV/VCR will come on and the language select display screen shown below will appear.

SELECT LANGUAGE

1 ENGLISH ON

2 ESPAÑOL

MAKE SELECTION OR

PRESS EXIT TO CONTINUE

2

Press the Number 1 button to select English on-screen displays or press the Number 2 button to select Spanish on-screen displays.

3

Press the STATUS/EXIT button. The channel program dis- play screen shown below will appear.

CONNECT ANTENNA OR CABLE

TO TVCR

THEN PRESS+

TO END PRESS EXIT

4

Press the F.FWD/+ button to begin automatic channel programming. The TV/VCR will place all of the channels you receive into its memory, so when you scan through channels using the CHANNEL Up/Down buttons, you’ll only scan through chan- nels that you receive. When channels are programmed, CHAN- NELS ARE SET will appear on-screen briefly. Then the TV/VCR will go to the lowest channel programmed.

(If you try to program channels when there is no antenna or cable connected to the TV/VCR, programming will appear to take place, but eventually a NO TV SIGNALS ... message will appear on- screen. Connect an antenna or cable to the TV/VCR, then try again. You may need to follow the steps on pages nine - 11 instead.)

5

Now, you may use the CHANNEL Up/Down buttons or the Number buttons on the remote control to select a TV/VCR chan- nel. Use the VOLUME Up/Down buttons to adjust the sound.

1	POWER				SLEEP
2		2		3	ALT.CH
	1
	4	5		6	o
					CHANNEL
	7	8		9	p
		0		+100	o
	SPEED			MUTE	VOLUME
					p
			o			4
			p
		PLAY
–	REW				F.FWD +
		STOP
	REC/OTR	MEMORY	PAUSE/STILL VCR PLUS+
	MENU	STATUS/EXIT		CLEAR	SMART
					SOUND

3

Helpful Hints

•If you do not see any on-screen dis- plays when you turn on the TV/VCR, check your hook-ups, then try again. If you still do not see any on-screen displays, follow the steps on pages nine - 11 to select a language and program channels.

•To skip this feature and play a tape immediately, insert a tape with its record tab removed. Playback will begin. Or, to skip step 2, press the STATUS/EXIT button before pro- ceeding. All on-screen displays will be in English. To skip step 4, press the STATUS/EXIT button before proceeding. Channels will not be programmed, and CHANNELS NOT SET will appear on-screen briefly.

•You cannot program channels if you are using a Cable Box.

•Line Input mode will always be stored in the TV/VCR’s memory as channel 00. When you select chan- nel 00, A/V IN will appear on- screen briefly. Press the CHANNEL Up/Down buttons or Number but- tons to select another channel.