Magnavox cmwR20v6 manual RF output switch, 80 EN, Error message, Cause

Others

Troubleshooting (cont’d)

Error message

Recording Error

You cannot record more than 49 titles on one disc.

(The maximum is 49)

Cause

•You are trying to record onto the disc on which the number of recording titles comes up to the maximum (49).

Solution

•Delete unnecessary titles (page 55).

		•You are trying to record onto the	•This unit cannot delete the original
	Recording Error
		VR mode DVD-RW disc on which	chapter. Delete unnecessary
You cannot record more than
		the number of recording chapters	chapter mark using other DVD
254 chapters on one disc.
		comes up to the maximum (254).	recorders. Delete unnecessary
(The maximum is 254)
			chapter marks (page 58).
		•When recordings are performed	•Insert a new disc.
	Recording Error
		repeatedly onto an unstable disc,
You cannot record on this disc
		this area may come up to be full.
as Power Calibration Area is
		•Every time you insert a disc for
full.
		recording, the disc’s working area
		will be taken up. And if you repeat
		this frequently, it will be used up
		sooner and you may not be able to
		record full 49 titles.
		•You are trying to record onto the	•Release the finalizing for this disc
	Recording Error
		disc already finalized.	(page 37).
This disc is already finalized.
		•You are trying to record onto the	•Set “Replace Disc Menu” to “ON” to
	Recording Error
		+VR formatting disc that had been	rewrite the menu, after that you will
The disc has a different menu
		recorded by the other recorder.	record to disc (page 27).
layout. (Set “Replace Disc
Menu” to “ON” to rewrite the
menu.)

•If you are still having trouble with this unit after checking Troubleshooting, write down the error code and the error description, and call our helpline mentioned on the front page to locate an Authorized Service Center.

You can watch the TV programs with the tuner of the unit. (Usually channel 3 or 4 of the TV is available for the RF converter setting.) Be sure to connect the unit to a TV using the RF cable. Refer to page 14.

1

Select channel 3 on your TV.

2

Press [VIDEO/TV] on the remote control.

•If noise appears, change the RF output channel of the unit to CH 4 by pressing [VIDEO/TV] for 3 seconds. The RF output channel will alternate between CH3 and CH4 as follows.

RF output switch

		•	Each time the RF output
		STANDBY-ON	channel is changed, CH3 or
VIDEO/TV	VCR	DVD OPEN/CLOSE	CH4 will appear on the front
.@/:	ABC	DEF	panel display.
1	2	3
GHI	JKL	MNO

for more than

3 seconds

3 seconds

(RF on) CH4

3 seconds

(RF on) CH3

3 seconds

(RF on) CH4

3 seconds

80 EN