MC09D1MG 3/22/02 1:15 PM Page 5
Putting Batteries in the Remote Control
| Remove the battery compartment lid on the bot- |
| tom of the remote control by sliding the lid down and |
1 off, following the direction of the arrow on the lid. | |
2 | Place two AA batteries inside the battery com- |
| |
| partment with their + and – ends aligned as indicated. |
3 Replace the battery compartment lid. | |
Battery Safety
●Battery Usage CAUTION - To prevent battery leakage that may result in bodily injury or damage to the unit:
Install ALL batteries correctly, with the + and - markings on the battery aligned as indicated on the unit;
Do not mix batteries, for example, old with new or carbon with alkaline; and
Remove batteries when the unit will not be used for a long time.
Before Using the TV/VCR 5
1
2 
3
Recording Prevention
Video cassette tapes have record tabs to ensure you do not erase recordings accidentally.
1 To prevent accidental recording, break off the tab with a screwdriver.
2 To record again, cover the hole with cellophane tape.
Using the Remote Control
●Point the remote control at the TV/VCR’s remote sensor.
●Do not put objects between the remote control and the TV/VCR.
TV/VCR Maintenance
●In this TV/VCR, use only tapes with the 
mark.
●Remove any light adhesive
●The TV/VCR requires periodic maintenance to maintain its excellent performance. This TV/VCR has an automatic head cleaning system. However, the video heads will eventually require cleaning or replacement. Only an authorized service center should perform this service.
1
2
Helpful Hint
•Your new product, its packaging, and this manual contain materials that can be recycled and reused. Specialized companies can recycle your product to increase the amount of reusable materials and to minimize the amount that needs to be properly disposed. Your product uses batteries that should not be thrown away when depleted but should be disposed of as small chemical waste. Please find out about the local regulations on disposal of your old product, batteries, manual, and packaging when you replace exist- ing equipment.
