Magnavox MDR533H Troubleshooting, Symptom, Remedy, Instructions continue on the next page

		TROUBLESHOOTING
	Symptom		Remedy
	DV signal cannot be input.		• Before connection, turn on the power supplies for both this unit and the
			DVC, and make sure that these units have stopped.
			• Only a “DVC-SD” signal can be input from the DVC to this unit. Other
			types of signals are not supported.
			• Do not connect any device other than the DVC. Even if a recorder or PC
			with another DV terminal is connected, the DV function will not operate.
			• If the DVC is not recognized after connection, turn off the power supply
			for the unit and re-connect the DVC.
	The DVC cannot be operated with this		• Signal input or DVC operation from this unit may be disabled
	unit.		depending on the type of DVC.
			• If a DVC signal cannot be input, use an external input (L1/L2) for analog
			connection via audio/video cables.
			• DVC control may be disabled depending on the type of DVC, even in a
			mode other than camera mode. In this case, switch to HDD/DVD control
			and execute the normal recording procedure while operating the DVC.
	Certain functions of the DVC cannot		• Some functions may not operate depending on the type of DVC. For
GENERAL	operate.		example, if the DVC does not support slow playback mode, the slow
			playback function is disabled.
			• With L3(DV-IN), the disc display menu does not appear unless disc
			playback is executed.
	DV audio signal cannot be switched.		• For recording with the DVC, the recording audio signal can be set to 12
			bits or 16 bits. However, when 16-bit recording mode is selected, audio
			signal cannot be switched. To record an audio signal, set it to 12 bits.
	No image from HDMI connection.		• Check the HDMI connection. (Check the status of the HDMI related
			indications.)
			• Check whether the connected monitor device or other device supports
			HDCP. (This unit will not output a video signal unless the other device
			supports HDCP.)
			• Check the setting of HDMI.
			• Check whether the output format of this unit (HDMI FORMAT) matches
			the supported input format of other connected device.
			• If above remedies do not work, unplug the HDMI cable and the AC
			power cords, then plug them back in the order of 1: HDMI cable, 2: AC
			power cord.
	Setup menu cannot be called up.		• Setup menus cannot be called up during DVD recording.
			• Press [STOP C] on the remote control, and then press [MENU].
	TV channels cannot be changed.		• Check if the connections are made securely and correctly.
			• Check if the cables are damaged.
			• Try channel setting by following the steps on pages 29-31.
CHANNEL	Only specific channels do not appear.		• The channels may be set to be skipped. (Refer to pages 30-31.)
	The unit is not picking up my channels		• Check the Connections. Confirm the main source from the Antenna/
	The external input channels (such as		• This unit does not skip the external input channels. This is not a
	L1, L2 or L3) cannot be skipped.		malfunction.
	from the Auto Scan.		Basic Cable/Cable Box/Satellite Receiver is connected to the ANTENNA
			IN by an “RF Coaxial” Cable. If not using the “RF Coaxial” cable and using
			an S-Video or RCA Audio/Video cable, the unit will need to be set on L1
			or L2.
		The image from the external device	• Try pressing [SOURCE] repeatedly.
RECORDING	GENERAL
		cannot be displayed or recorded.	• Turn on all connected devices.

• Check if the connections are made securely and correctly.

Instructions continue on the next page.

Introduction Connections Basic Setup Recording Playback

Editing Function Setup Others

Español

EN 117