Magnavox MDV540VR/17 Disc Playback, Press STANDBY-ON to turn on the DVD/VCR, Press OPEN/CLOSE a

H9660UD_1.qx4 04.4.14 4:47 PM Page 19

Before you begin, turn on the TV, Stereo, and other equipment connected to the DVD/VCR. Make sure the TV and the Stereo (if applicable) are set to the correct channel.

Details are on pages 7-15.

1 Press STANDBY-ON to turn on the DVD/VCR.

2 Press DVD to put the DVD/VCR in DVD mode.The DVD light will appear on the front of the DVD/VCR.

3 Press OPEN/CLOSE A (to the left of the disc tray on the front of the DVD/VCR) to open the Disc tray.

4 Place a Disc into the tray. If the DVD is recorded on only one side, place the Disc in the tray with the label fac- ing up and the shiny side facing down. Some DVDs are recorded on both sides. Make sure the label of the side you want to play is facing up.

5 Press PLAY B. The tray will close and play will begin at the first Chapter or Track. If a DVD menu appears instead, see page 48. With some Audio CDs, playback will not begin unless you press PLAY B.

Or, press OPEN/CLOSE A or press the tray toward the DVD/VCR to close the tray.

With MP3 and JPEG files, playback will begin from the beginning of the disc.

6 Press STOP C to stop playback.

Remember, this DVD/VCR will play only certain Discs.

See page six for details.

Disc Playback 19

			STANDBY-ON	1
	TIMER SET
	SETUP	AUDIO SUBTITLE	ANGLE
	REC	REPEAT	REPEAT
			A-B
	PREV/	C-RESET	NEXT/
		CLEAR
	CH		CH
	TITLE	MODE	RETURN	2
		DISPLAY
	VCR		DVD
	DISC
	MENU		OK
6	STOP		PLAY	5
	SEARCH	PAUSE	SEARCH
	REW		FF

3 Press OPEN/CLOSE A

on the DVD/VCR.

4Insert a Disc.

Helpful Hints

•An “X” may appear at the top right corner of the TV screen when you try a feature. Either the feature is not available on the Disc, or the DVD/VCR cannot access the feature at this time.This does not indicate a problem with the DVD/VCR.

•If a Disc is dirty or scratched, the picture may appear distorted or playback may stop. Remove the Disc and turn off the DVD/VCR. Disconnect the power cord, then reconnect it. Clean the Disc, then turn on the DVD/VCR again and reinsert the Disc for playback.

•When the DVD or CD light appears on the display panel, the Disc is loaded and ready for playback.

•When you press OPEN/CLOSE A or PLAY (DVD) on the front of the DVD/VCR when the power is off, the DVD/VCR will turn on in DVD mode. Otherwise, the DVD/VCR will turn on in the mode in which it was turned off.