Magnavox MME239 Multi, Ntsc, Pal, To remove the menu Press System Menu, Progressive Scan TV only

Getting Started

1In disc mode, stop playback then press

SYSTEM MENU.

➜ The menu bar will appear across the top of the TV screen.

2Select icon and press 4.

3Press à / á / 4 / 3 keys on the remote control to navigate in the menu.

➜Move to , and press á.

➜Move to “TV TYPE” , and press á.

MULTI

–Select this if the connected TV set is compatible with both NTSC and PAL (multi system).The output format will be consistent wit the video signal of the disc.

NTSC

–Select this if the connected TV set is NTSC system. It will change the video signal of a PAL video disc and output to NTSC system.

PAL

–Select this if the connected TV set is PAL system. It will change the video signal of an NTSC disc and output to PAL format.

4Select an item and press OK.

➜ The screen messages for further setting confirmation may appear. Follow the on-screen instructions to proceed to confirm the setting or not.

To remove the menu

Press SYSTEM MENU.

Setting up Progressive Scan feature (for

Progressive Scan TV only)

The progressive scan display twice the number of frames per seconds than interlaced scanning (ordinary normal TV system). With nearly double the number of lines, progressive scan offers higher picture resolution and quality.

IMPORTANT!

Before enabling the progressive scan feature, you must ensure:

1)Your TV can accept progressive signals, a progressive scan TV is required.

2)You have connected the DVD player to your TV using Y Pb Pr (see “Connecting TV set”)

1Turn on your TV.

2Turn off your TV progressive scan mode or turn on interlaced mode (refer to your TV user manual).

3Press STANDBY-ONB to turn on the DVD player.

4Select the correct Video Input channel.

5Press SYSTEM MENU on the remote control. ➜ The menu bar will appear across the top of the TV screen.

6Select icon and press 4.

➜ Playback will pause.

TV DISPLAY

TV TYPE

PROGRESSIVE OFF

ON

SCREEN SAVER

PROGRESSIVE NOW ON

7Press à / á / 4 / 3 keys on the remote control to navigate in the menu.

➜Move to , and press á.

➜Move to “PROGRESSIVE” , and press á.

➜Move to “ON”, and press OK.

➜The screen message below appears on the

TV.

ACTIVATING PROGRESSIVE SCAN

1.ENSURE YOUR TV HAS PROGRESSIVE SCAN.

2.CONNECT USING YPRPB(RGB) VIDEO CABLES

3.IF THERE IS A BLANK SCREEN, WAIT FOR 15 SECONDS FOR AUTO RECOVER.

<>-MOVE OK-SELECT

8Press à / á to highlight OK in the menu and press OK on the remote to confirm.

➜ The screen message for further progressive scan setting confirmation will appear.

There will be a distorted picture on your TV at this state until you turn on the progressive scan mode on your TV.

9Turn on your TV progressive scan mode (refer to your TV user manual).

0In the confirmation menu, press à / á to highlight OK in the menu and press OK on the remote to confirm.

English

19