1Connect your Antenna or Cable TV signal to the ANTENNA IN jack
on the rear of the Recorder.
2Connect an S-Video cable (not supplied) to the Recorder’s S-VIDEO
OUT jack and to the TV’s S-VIDEO In jack.
3Connect the supplied audio cable to the Recorder’s white/red
AUDIO OUT L/R (left/right) jacks and to the left/right AUDIO IN
jacks on the TV.Match the cable colors to the jack colors.
4Connect the supplied RF coaxial cable to the (ANTENNA) OUT
jack on the rear of the Recorder. Connect the other end of the
same RF coaxial cable to the Antenna In jack on your TV.Your TV’s
Antenna In jack may be labelled RF In,Antenna In, or 75 ohm.Check your TV’s
manual for details.
5Connect the power cords of the Recorder and the TV to a power
outlet.
6Press STANDBY-ON yyto turn on the Recorder.If “IS TV ON? C03”
appears on the display panel,you need to turn on your TV and set it to the S-
Video In channel.(See next step.) You cannot see the Initial Setup screens until
you turn on the TV and have it on the correct S-Video In channel.
7Turn on the TV power. Set the TV to the S-Video In channel.This is
not channel 3 or 4 when you are using S-Video. Your TV remote may have a
button or switch that selects the S-Video In channel.Or, go to your lowest TV
channel and change channels down until you see the DVD background picture
or Initial Setup screen on the TV.The Initial Setup screen will appear the first time
you turn on the Recorder.Go to page 18 to continue.
Hookups (cont’d) 13
Connecting to a TV Only
TV has an S-Video In Jack
On the TV, the S-Video In jack
may be labeled Y/C,S-Video, or
S-VHS (super video).
Helpful Hint
E9490UD_EN.qx3 04.8.3 11:55 AM Page 13