Magnavox ZC357MGX Setting the Clock, Auto Clock Setting, Press Setup and turn the unit to

1 Press [SETUP] and use [K / L] to select “General Setting”, then press [OK].

“General Setting” menu will appear.

2 Use [K / L] to select “Clock”, then press [OK].

“Clock” menu will appear.

3 Use [K / L] to select “Auto Clock

Setting”, then press [OK].

4 Use [K / L] to select “Auto”, then press [OK].

Auto Clock Setting

OFF

Auto

Manual

5 Press [SETUP] to exit.

6 Press [STANDBY-ONy] to turn the unit to the standby mode.

This unit will search for the time only when the power is in the standby mode. Leave it in standby for several minutes to give this unit time to set the clock.

If the unit chooses an incorrect PBS channel, set the PBS channel manually by following the steps below.

1 Select “Manual” at step 4, then press [OK].

2 Use [the Number buttons] or [K / L] to enter your PBS channel number, then press [OK].

Set Channel No.

SETTING THE CLOCK

Set the clock before you try the timer programming. If a PBS (public broadcasting station) is available in your area, follow “Auto Clock Setting” below. If not, follow “Manual Clock Setting” on page 30.

Auto Clock Setting

This unit can set the time and date automatically by referring to a PBS station.

Make sure

• The antenna/cable TV connections are correct.

• Channels are set. (Refer to page 26.)

• If this unit is connected to a cable/satellite box, select the local PBS station on them to set the clock automatically.

Note			CH	1
• The clock may set itself automatically after you
	3
connect the antenna/cable signal and plug in the		Press [SETUP] and turn the unit to
power cord.		the standby mode.
• Only the analog PBS channel signal is effective for
auto clock setting.

• The unit receives the clock data at 12:00 a.m. / p.m. from the PBS channel when the unit is in the standby mode.

Introduction Connections Basic Setup Recording Playback Editing Function Setup Others

Español

EN 29