11.1: If a brake assembly will not be installed immediately, it can be stored indoors in a dry location indefinitely or outdoors for a reasonable time if adequately protected from moisture and corrosive atmosphere. The brake assembly must always be protected from direct exposure to the elements unless specifically treated at the factory for use in that environment. Covering with plastic sheeting is not acceptable unless provision is made to prevent condensation under the plastic.
11.2: During storage, rust may form on the surface of the brake wheel. This is not usually a problem with ductile iron wheels nor is it necessary to clean the wheel before placing the wheel in service. The first few brake applications will polish the wheel.
11.3: Steel wheels may form scale when corroded, and the braking surface may have to be re- machined to remove the scale. See Table 4 for machining limits. Dynamic balance may be affected.
11.4: Before painting a brake, protect all pivot points,
11.4.(a): Data plates and labels must not be removed or painted over.
8/17/2006 | Page 33 of 33 | MST/E Electric Shoe Brakes Manual |
|
|