UVSRC
Read all the installation instructions for the applicable appliance before begin- ning the installation of the blower.
UVSRC36A Blower Installation
Step 1: Carefully unpack the blower assembly and familiarize yourself with the parts. Care should be taken not to damage the fan blades or housing.
Step 2: The SCVS - Variable Speed Control Kit (or standard wall switch) should be installed before the blower assembly installation. Please refer to instruc- tions found in the SCVS Kit.
Step 3: Remove the bottom brick from the fireplace and carefully place it to the side to prevent damage. Use a flat blade screwdriver to gently lift up the front edge of the brick, then pull forward to remove.
Step 4: Locate the blower access cutout found at the rear of the hearth pan. Next, remove tape backing from tape on blower housing. Center the blower assembly in the access cutout area with the blower outlet duct pointing upward, then press firmly to attach foam tape to the back and bottom of the fireplace. (Fig. 9)
Step 5: Locate the junction box cutout found on the right side of the hearth pan. Route the powercord under the hearth pan and plug it into the receptacle outlet found in the junction box. (Fig. 10)
Step 6: Turn power back on and test blower operation.
Step 7: Replace the bottom brick in the fireplace.
UVSRC42A Installation
Step 1: Carefully unpack the blower assembly and familiarize yourself with the parts. Care should be taken not to damage the fan blades or housing.
Step 2: The SCVS - Variable Speed Control Kit (or standard wall switch) should be installed before the blower assembly installation. Please refer to instruc- tions found in the SCVS Kit.
Step 3: Remove the metal hearth cover and the bottom two right brick panels from the fireplace and carefully place them to the side to prevent damage. Step 4: Locate the blower access cutout found at the rear of the hearth pan. Next, remove tape backing from tape on blower housing. Center the blower assembly in the access cutout area with the blower outlet duct pointing upward, then press firmly to attach foam tape to the back and bottom of the fireplace. (Fig. 9)
Step 5: Locate the junction box cutout found on the right side of the hearth pan. Route the powercord under the hearth pan and plug it into the receptacle outlet found in the junction box. (Fig. 10)
Step 6: Turn power back on and test blower operation.
Step 7: Replace the metal hearth cover and the bottom two right panels in the fireplace.
Blower | Back Firebrick |
Access |
|
Cutout in |
|
Hearth Pan |
|
NOTE: Hearth brick and/or hearth cover is removed as shown to gain access for blower and junction box
installation.T230
Fig. 9 | Blower access. |
| Receptacle |
| Outlet in |
| Junction |
| Box |
| Junction Box Cutout in |
| Hearth Pan of Firebox |
| T231 |
Fig. 10 Route powercord under the hearth pan and plug into the receptacle outlet.
Finishing the Fireplace
There are a wide variety of finishing materials available for your fireplace from formal wall treatments with marble and mantels to rustic wood paneling, stone or brick.
IT IS IMPORTANT THAT THE BLACK FACE OF THE FIREPLACE NOT BE COVERED WITH ANY TYPE OF COMBUSTIBLE MATERIAL.
Noncombustible facing materials such as marble, brick or ceramic tile may overlap the black face of the fireplace up to the opening on either side of the fire- place. Seal all joints between the black fireplace face and the wall covering with a
8 | 20007435 |
