notice the adjustment is off, kindly do as f 01I ows.)
Loosen the pan head screw for each roller under the table. Use a screwdriver to rotate the groove on the roller adjuster within 180 degrees on the four roller axes. Refer to the figures for the correct range of adjustment of each roller adjuster. Rotat- ing the groove in the ascending direction causes the bed roller to rise; turning the groove down causes the bed roller to lower.
NOTE : | Range of groove rotation on roller adjuster |
The above adjustment procedure should be | to adjust height o f bed roller (left). |
Range of groove roation on roller adjuster to adjust of bed roller (right).
Fig. 11
Caution
Unless the two groove positions on the one roller face the same direction, the stock may be twisted to the left or right.
I f the rollers protrude too much, notching may result in the surface planed on the opposite end. The protrusion from the table surface should be 0.1 - 0.3mm (postcard thickness). Tighten the small screw when the adjustment has been made.
