MA1NTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
Cleaning
Clean out sawdust and chips from time to time.
Carefully clean the balde guard and moving parts inside the table saw.
Lubrication
To keep the table saw in
Use machine oil #I20 to wet the felt on the slide table and the bars.
Use grease or machine oil #I20 for the moving parts under the table.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the timit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced a t the same time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. To replace the carbon brush in the side near the table, lower the blade as far as possible by turning the knob. Loosen the lock lever, tilt the blade and secure it a t 45 degrees. Then loosen the brush holder cap while viewing it through the opening in the base.
Remove the worn carbon brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
24
