When installing two outside cutters without any inside cutter, be sure that the cutter tips do not face each other.
0 X
@While tightening the hex nut, be careful to maintain the even spacing between the tips of the inside cutters.
@When cutting 1/2" or narrower grooves, use the table insert originally installed on the table saw. When cutting 9/16" or wider, use optional accessory table insert (Part No.
@Rotate the dado head one turn by hand to make sure that it does not contact anything before operation.
When dadoing, use featherboards. The diagram shown illustrates dimensions for making a typical featherbord. It should be made from a straight piece of wood that is free of knots or craks.
Kerf should be
2 7
