Install the blade between the two flanges.
Then install
the
outer flange and hex nut
onto the arbor, making sure the teeth of
the blade are pointing down
at
the front
of
the table.
To secure the blade in place, hold the outer
flange with the offset wrench, then tighten
the hex nut counterclockwise with the
wrench. When tightening the hex nut, the
offset wrench handle should be supported
by the table
as
shown in the figure. BE
SURE
TO TIGHTEN THE HEX NUT
SECURELY.
CAUTION
:
Be sure to hold the hex nut carefully with the wrench.
If
your grip should slip, the
wrench may come off the hex nut, and your hand could strike the sharp blade edges.
9