Makita 3702B instruction manual Wave washer Flat washer Bolt

Circular work

0Circular work may be accomplished if you assemble the straight guide and guide plate as shown in the figure below.

0 Min. and max. radius of circles to be cut (distancebetween the center of circle and the center of bit) are as follows :

Min. : 70 mm (2-3/4")

Max. : 221 mm (8-11/16") (Note)

Circles between 172 mm (6-3/4") and 186 mm (7-5/16") in radius cannot be cut using this guide.

Wave washer

Flat washer

Bolt I

_ _

For cutting circles between 70 mm (2-3/4") and 121 mm (4-3/4") in radius.

Align the center hole in the straight guide with the center of the circle to be cut. Drive a nail less than 6 mm (1/4") in diameter into the center hole to secure the straight guide. Pivot the tool around the nail in clockwise direction.

Wing nut

:Flat washer Center hole

Guide plate

IV	Straight guide
	Bo1t
	~

For cutting circles between 121mm (4-3/4") and 221 mm (8-11/16") in radius.

i_Straight guide

9