Refer to the table a t right t O Select the pro- per speed for the workpiece to be cut. However, the appropriate speed may differ
with the type or thickness of the work- piece. In general, higher speeds will allow
you to cut workpieces faster but the service life of the blade will be reduced.
Workpiece to be cut Number on adjusting dial
Mild Steel
Stainless Steel
Aluminum
Plastics
CAUTION :
Adjust the speed adjusting dial only within the range of numbers 1 through 6. Do not force the dial beyond this range or damage to the tool may result.
Cutting operation
CAUTION :
Always hold the tool with the base flush with the workpiece. Failure to do so may cause
aslanted cutting surface and blade breakage.
.Advance the tool very slowly when cutting curves or scrolling. Forcing the tool may cause a slanted cutting surface and blade breakage.
Turn the tool on without the blade making any contact. Rest the base flat on the workpiece and gently move the tool for- ward along the previously marked cutting line.
Bevel cutting
CAUTION :
Always unplug the tool before making any adjustments.
With the base tilted, you can make bevel cuts a t any angle between 0" and 45" (left or right). Loosen the base securing lever and move the base so that the dent mark in the motor housing is aligned with the slot in the base. Tilt the base until the desired bevel angle is obtained. The edge of the motor housing indicates the bevel angle by graduations. Then tighten the base securing lever to secure the base.
NOTE :
Always remove the plastic cover (chip shield) from the tool when you make bevel cuts using an optional guide rule (rip fence) or circular guide.
Base securing
lever
8
