Base Complete, Assembling | Makita 5007MG-R specs

ASSEMBLING		Fig. 4

1) Assemble Spacer and Safety cover to Bearing box.
(Fig. 3 on page 2)
2) Assemble Safety cover to Bearing box.
(Fig. 3 on page 2)
Link Safety cover to Blade case with Tension spring 4
as illustrated in Fig. 4.
Note: Be sure to follow the instructions in Fig. 4.
Otherwise, pivoting action of Safety cover
will be interfered by Tension spring 4.
3) Secure Safety cover to Bearing box with Retaining
ring S-42. Fasten Rubber sleeve 6 to Blade case with		side
Pan head screw M6x20. (Figs. 1, 2 on page 2)
		Blade

P 3/10

Pass the hook of Tension spring 4 through the hole on Safety cover

Safety cover

Bearing box side

Tension spring 4

Blade case

Pass the hook of Tension spring 4 through the hole on Blade case

from Blade side to Bearing box side.

[3] -2. Base Complete

Note: The above illustrations show the conditions after removal of Safety cover.

It is not necessary to remove Safety cover when replacing Base complete.

1)Loosen Hex nut M8-13 by turning Lever 56 (the one used for bevel angle adjustment) in the direction of the arrow as illustrated in Fig. 5.

2)Remove Bow stop ring E-12 from Hex nut M8-13 using slotted screwdriver as described in Fig. 6.

3)Remove Lever 56, Hex nut M8-13 and Flat washer 8 from Flat-head square-neck bolt M8x24.

Then remove Flat-head square-neck bolt M8x24 by pushing it in the direction of the black arrow. (Fig. 7)

Fig. 5

Fig. 6

Lever 56

(the one used for

bevel angle adjustment)

Hex nut M8-13 Bow stop ring E-12

Remove Bow stop ring E-12 from the groove of Hex nut M8-13 by twisting the ring using slotted screwdriver.

Bow stop ring E-12

Hex nut M8-13

Fig. 7

Flat-head square-neck bolt M8x24

Flat washer 8

Hex nut M8-13

Lever 56 (the one used for bevel angle adjustment)